MTD Log Splitter 753 05193 User Manual

Date:  
9/23/2005  
Log Splitter Wedge Shim  
Subject:  
Service Kit  
753-05193  
2004 and 2005 Model Year Log  
Splitters built between May 1,  
2004 and September 15, 2005.  
Models  
Affected:  
Read through and understand these instructions completely before proceeding with repair.  
PURPOSE:  
This service kit provides a shim (spacer) to reduce the gap between the end of the cylinder ram and the back of the  
wedge. Perform the Pre-service Inspection to determine if this kit is required or not.  
NOTE: These materials are prepared for use by trained technicians who are experienced in the service and repair  
of equipment of the kind described in this publication, and are not intended for use by untrained or inexperienced  
individuals. Such individuals should seek the assistance of an authorized service technician or dealer.  
NOTE: Save this Instruction Sheet. Refer to it when ordering replacement parts.  
Service Kit Contents  
1
(See Figure 1)  
ITEM  
NO.  
1
2
3
PART  
NUMBER  
681-04052  
710-1806  
712-3022  
769-02077  
QTY  
DESCRIPTION  
1
1
1
1
SHIM ASSEMBLY  
SCREW: HHCS: 1/2”-13 x 3.25: GR5  
NUT: LOCK: 1/2”-13  
3
4
THIS INSTRUCTION SHEET  
Pre-service Inspection:  
These instructions are written with the assumption that  
the unit has been in service already or is being prepared  
for delivery.  
2
FIGURE 1  
1. To determine if this service kit is required the follow-  
ing check must be made.  
If the gage does not go in the gap, the gap is cor-  
rect and this kit is not required. Stop here.  
2. Place beam in the horizontal position and lock in  
place.  
If the gage goes into the gap, the shim provided  
should be installed. Proceed to Step 9.  
3. Check engine oil level and hydraulic fluid level.  
4. Start engine and extend ram so the splitting wedge is  
about 4”- 8” from beam’s foot. Turn off engine.  
PUSH  
Wedge  
Back  
.
5. Release pressure in the system by shuttling the direc-  
tion control lever from the forward to the retract positions  
several times.  
.035"  
max.  
6.Using two 3/4” wrenches loosen the cylinder to wedge  
mounting bolt to relax the wedge.  
7. With wood blocking braced against the beam’s foot,  
push the wedge back toward the cylinder’s ram end and  
secure in this position.  
GAP  
8. Using a.035” feeler gage, try to insert the gage  
between the end of the ram and the back side of the  
wedge pocket. See Figure 2.  
FIGURE 2  
Service Kit 753-05193  
Pg 1 of 2  
Form No. 769-02077  
 

Milton Bradley Board Games 5844 User Manual
MSi Computer Hardware CX700 User Manual
Murphy Network Card ST8 User Manual
NEC Marine Instruments MultiSync LCD4215 User Manual
NeumannBerlin Microphone TLM 193 User Manual
OEM Systems Speaker System PLT 522G User Manual
Omega Speaker Systems Thermometer HH11B User Manual
Omron Healthcare Blood Pressure Monitor HEM 711DLX User Manual
Panasonic Air Conditioner CS S12JKUW User Manual
Panasonic Security Camera GP KS162CUD User Manual